Used IKEA modules:
- Besta Frame 60x40x192 (W,D,H)
- 2xBesta Shelf 56×36 (W,D)
- Besta Drawer frame 60x40x25 (W,D,H) (optional)
- Besta drawer runner push-open (Optional)
- Lappviken door 60xx64 (W,H)
- Lappviken drawer front 60×38 (W,H) (optional)
- Lack Side table (only the legs are needed)
- Utrusta push opener
- 4x carriage bolt
- 4x Tessauer nut
This is a quite simple hack for creating a hidden, space saving coffee table almost completely out of IKEA parts. (all the sizes are in mm)
Build the ordinary Besta tall frame. Place one of the shelves according to the manual just if you would have wanted to have a cabinet with door in the lower 1/3 section.
Place the second shelf under the first one with two skipped pre-drilled holes. Attach the two push-opener mechanism as shown in the picture.
Drill holes into each corner of the Lappviken door with the size given. You may try in the bolts.
Use a cutter to make place for the necks of the bolts. Cut only the upper side of the door. And don’t go too deep.
Cut the legs of the LACK table. The size is given. (Strictly use table saw!)
Make place for them, and place the tessauer bolts.
Assemble the table.
Enjoy the table, or hide it.
Optional Hidden Drawer
If you don’t want to leave a huge open area where the table top was (when the table is use), then follow these steps:
An ordinary drawer front won’t be good, because its place is in front of the frame. That is why we have to hack it, to make it fit behind the table.
Cut the Lappviken drawer front to match the size given. (use table saw)
WARNING: with the following sizes you will get the same result as I had. The shelf’s top plane will be higher than the drawer front’s edge.
Drill holes into the drawer front as the measures are given. OR
Subtract 9-10 mm from the given sizes, and drill those holes with the new sizes.
Place the drawer runner one place further back as shown in the manual.
Assemble the drawer with the hacked front panel.
Enjoy your work!